Medtronic iPro2 Guía de usuario descargar pdf (Pagina 8)

6 CGMS

iPro

Continuous Glucose Recorder User Guide

CGMS iPro Magnetic Wand interference

Do not store the CGMS iPro Magnetic Wand or any other magnet within 1.5 inches (3.8

cm) of the CGMS iPro Digital Recorder. Premature battery discharge may occur.

Do not place the CGMS iPro Magnetic Wand or any other magnet within 1.5 inches (3.8

cm) of the CGMS iPro Digital Recorder except while performing patient set-up and data

download procedures. Premature battery discharge may occur.

CGMS iPro Magnetic Wand interference with insulin pumps

Do not place the CGMS iPro Magnetic Wand directly on any insulin pump. Incorrect

pump operation may occur.

Do not insert the glucose sensor with attached CGMS iPro Digital Recorder closer than

two to three inches (5.08 - 7.62 cm) from the insulin pump. The use of the CGMS iPro

Magnetic Wand may inadvertently cause incorrect operation of the pump.

CGMS iPro Magnetic Wand interference with PC hard drives

Do not place the CGMS iPro Magnetic Wand on your PC or external hard drives, as the

magnetic field may impact the integrity of the data files stored there.

Other electromagnetic interference

The CGMS iPro Digital Recorder is designed to withstand common electromagnetic

interference, including airport security systems.

Precautions

If performing multiple CGMS iPro Digital Recorder studies on the same patient, establish

a rotation schedule for choosing new glucose sensor sites. Avoid sites that are

constrained by clothing, have scar tissue, or are subject to rigorous movement during

exercise.

If any blood gets inside the digital recorder connector, the digital recorder must be

discarded.

If you do not plan to use the digital recorder for at least 30 days, connect it to the

charger for storage. The charger will not keep the digital recorder charged, but it will

slow the digital recorder’s battery discharge. Remove the digital recorder from the

charger at least once every 60 days, wait at least one minute, then reconnect the

digital recorder to the charger. To use the digital recorder after it has been stored,

disconnect it from the charger, wait at least one minute, then reconnect it again to

start the charging process. It may take up to eight hours to fully charge a digital

recorder that has been stored for more than 30 days.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Sin comentarios

Medtronic iPro2 Guía de usuario Pagina 8