Medtronic Paradigm 522 Guía de usuario descargar pdf (Pagina 141)

Connecting the transmitter to the sensor

Before connecting the transmitter to the sensor

, you must have the transmitter fully charged and set up

(see Charging the transmitter and Entering the transmitter ID sections in this chapter). You must also

have the features set up and the sensor inserted (see the instructions in this chapter and those provided

with your sensor). Allow at least one minute after disconnecting the transmitter from the charger before

you can connect it to the sensor.

1 After the sensor is inserted, wait five minutes before connecting the transmitter. Check for bleeding.

Make sure that any bleeding has stopped, then connect the transmitter to the sensor

2 Touch the inserted sensor at back of assembly to prevent movement.

sensor

3 Hold the transmitter as shown to line up the two notches on both sides with the flexible side arms of

the sensor. The transmitter's flat side with the label should face the skin.

4 Slide the transmitter onto the sensor and push it in firmly until the flexible side arms of the sensor

click into the notches on both sides of the transmitter. In the next 20 seconds the transmitter light will

flash green for about 10 seconds with a proper connection.

5 If the transmitter light does not flash, disconnect it from the sensor, wait for one minute and then

reconnect. If the transmitter light still does not flash, charge the transmitter.

6 After the transmitter light flashes green, use your pump to start communicating with the sensor and to

start the sensor initialization. See the next section.

Sensor features122

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 261 262

Sin comentarios

Medtronic Paradigm 522 Guía de usuario Pagina 141