Medtronic Revel Guía de usuario descargar pdf (Pagina 135)

The transmitter

The Medtronic MiniLink Transmitter (MMT-7703) is a device that takes electronic signals generated by the

glucose sensor and sends them by radio frequency to the pump. It has a tester (MMT-7706) and a charger

(MMT-7705 or MMT-7715). For details on how to use your transmitter, charger and tester, see your

transmitter user guide.

Starting the sensor

To start the sensor working, you must complete the following steps in order:

• Insert a battery into the transmitter's charger.

• Charge the transmitter battery.

• Set up the sensor features.

• Insert the sensor and wait 10-15 minutes.

• Connect the transmitter to the sensor.

• Start the sensor and wait two hours.

• Enter your first meter BG.

Inserting the sensor

Refer to your Sensor User Guide for information on sensor insertion.

Removing the sensor

When you are ready to change your sensor, disconnect it from the transmitter as described in your

transmitter user guide. Gently pull the sensor from your body to remove it. Place it in a sharps container.

Preparing the sensor for communication

Connect your transmitter to your sensor as described in the transmitter user guide. When the green light

on the transmitter flashes, use your pump to follow the steps below.

1 Go to the LINK SENSOR MENU screen.

Main > Sensor > Link to Sensor

2 Select New Sensor. Press ACT.

Sensor features114

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 264 265

Sin comentarios

Medtronic Revel Guía de usuario Pagina 135