Medtronic Revel Guía de usuario descargar pdf (Pagina 176)

What is a CHECK SETTINGS alarm?

This alarm occurs after an E alarm or after you clear your pump. It is advising you to make sure that all

your settings are correct. A CHECK SETTINGS alarm occurs after any of these actions:

• All user settings were cleared (set back to their defaults) because there was an E-error alarm,

• The Clear Settings function was performed, or

• After you rewind when practicing without a reservoir when you first get your pump. In this case, it is

just a reminder to make sure all your settings are programmed before you begin using the pump with

insulin.

My screen appears distorted

The screen may appear distorted or have a rainbow-like appearance if you are wearing polarized

sunglasses, are in bright sunlight, or in extreme high or low temperatures. If your screen appears

distorted:

• Take off your sunglasses.

• Move into the shade.

• Make sure your pump is not in direct heat (next to a heater) or cold (worn on the outside of your

clothing on a very cold day).

• Do not return the pump: this is a normal property of this type of screen on any device.

The pump is asking me to rewind

This is normal after any of the following:

1 Any E-alarms,

2 The Clear Settings function,

3 Or, a NO DELIVERY alarm (during the Reservoir + Set sequence).

My bolus stopped

The Bolus Stopped error can occur if the battery cap is loose or the pump was bumped or dropped during a

bolus. It can also happen if the pump receives a static shock. As a safety measure, the pump stops the

bolus when this happens.

1 If you dropped your pump, visually inspect it to make sure that it is not damaged in any way.

2 Review your bolus history and reprogram the remaining bolus, if needed.

Troubleshooting, alerts and alarms 155

Chapter 13

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 264 265

Sin comentarios

Medtronic Revel Guía de usuario Pagina 176